Operator cocks the hammer, takes careful aim, pushes the safety to the left, then, squeezing the trigger, he fires. The operator then analyzes shot effect and decides whether to reload and repeat, or to depart the area with all due haste.

• In the event of a misfire, the operator announces “Misfire,” then pushes the safety to the right and “On,” announces “Safe” and the A-gunner makes a fast visual inspection to see if the grenade was properly indexed or not. High probability in a misfire will be that the grenade was not properly seated. If that is the case, the A- gunner then immediately reseats the grenade and initiates checks. Operator fires again. If the grenade was in place, then the A-gunner should pull the grenade forward and visually inspect the primer for a hit. If no hit, try again. If there is a dented primer, then the grenade should be gingerly moved away from the area and left for EOD (on the range) or blown in place at the first opportunity if in the field.

• If there is another misfire, then the A-gunner removes the grenade and inspects the primer. If there is no hit on the primer, then there must be a full check done on the pistol group and firing pin. The A-gunner should re-install the fuze cover and safety pin, then remove the round and unscrew and store the expeller charges and grenades in their carry cases. Under no circumstances should the expeller charges be left attached to the grenades and carried around. The reasons for this should be clear from the discussion of how the rounds work.